Choc V1 Keycaps - Ergonomic Design

These are custom-designed keycaps for Choc V1 switches, with a focus on ergonomics and better character than standard flat keycaps commonly used in ortho and split keyboards.

Production Details

Printed on a Mars 4 resin printer and finished with 3 coats of 1000 grit black surfacer. The result is surprisingly good for 3D printed keycaps, both in look and feel.

Technical Specs

• 2.25U and spacebar include stems for Kailh Choc v1 stabilizers
• Spacebar works with 6.25U stabilizer (100mm cross mount)
• 2.25U works fine without stabilizers

I want your feedback!

The spacebar and 2.25U can warp slightly during printing. This shouldn't matter for most Choc v1 builds since they rarely use these sizes.

Feel free to message me if you:

• Need different key sizes
• Need the stem sizes tweaked (only tested with PLA on Bambu P1s and Mars 4 resin)
• Have feedback on the design
• Need advice on painting/surfacing (went through a lot of different products to get this right)
• Want to share your printing experience